Overhead Rigging - JB Systems DynaSpot Bedienungsanleitung

ENGLISH

OVERHEAD RIGGING

 Important: The installation must be carried out by qualified service personal only. Improper
installation can result in serious injuries and/or damage to property. Overhead rigging requires
extensive experience! Working load limits should be respected, certified installation materials
should be used, the installed device should be inspected regularly for safety.
 Make sure the area below the installation place is free from unwanted
persons during rigging, de-rigging and servicing.
 Locate the fixture in a well ventilated spot, far away from any flammable
materials and/or liquids. The fixture must be fixed at least 50cm from
surrounding walls.
 The device should be installed out of reach of people and outside areas
where persons may walk by or be seated.
 Before rigging make sure that the installation area can hold a minimum
point load of 10times the device's weight.
 Always use a certified safety cable (number 3 on the picture) that can hold
12 times the weight of the device when installing the unit. This secondary
safety attachment should be installed in a way that no part of the
installation can drop more than 20cm if the main attachment fails.
 The device should be well fixed; a free-swinging mounting is dangerous
and may not be considered!
 Don't cover any ventilation openings as this may result in overheating.
 The operator has to make sure that the safety-relating and machine-
technical installations are approved by an expert before using them for the
first time. The installations should be inspected every year by a skilled
person to be sure that safety is still optimal.
HOW TO SET UP THE UNIT
FRONT + BACK PANEL:
1. DISPLAY: shows the various menus and the selected functions.
2. BUTTONS:

MODE-button: used to enter and leave the setup menu.

UP/DOWN-buttons: browse the setup menu up/down and change the value of parameters.

ENTER-button: confirm your actions.
3. IR REMOTE RECEIVER: receives the infrared instructions from the IR-remote while the unit is used in
standalone or master/slave mode.
4. DMX IN/OUTPUTS: used for DMX512 linking, use balanced signal cables with 3pin XLR-connectors.
5. USB 5Vdc output: this is NOT a data connector, it's only a 5Vdc/350mA output that can be used to
supply power to future accessories.
6. MAINS INPUT/OUTPUT: with IEC socket and integrated fuse holder, connect the supplied mains cable
here. You can use a special IEC power cable to connect the output with the mains input of the next unit
for easier linking up to 10A.
Hint: Please check our website for special cable assemblies that contain both power and balanced
signal (XLR 3pin) in one cable. Different lengths are available: 1.3m, 3m, 5m and 10m, very convenient!
7. SAFETY EYE: fix an optional safety cable here when the unit it installed above the crowd.
8. U-BRACKET: used when the projector is fixed in truss using a standard ALU-clamp.
JB SYSTEMS
®
3/59
USER MANUAL
DYNASPOT