Troubleshooting - Silverline 870944 Bedienungsanleitung

GB

Troubleshooting

Problem Possible cause Solution
No power Check power supply
No function when On/Off Switch
(2) is operated
Defective On/Off Switch Have the On/Off Switch replaced by an authorised Silverline service centre
Slow material removal Sanding sheet too fine or worn Fit new sanding sheet with coarser grit
Sanding sheet too coarse Fit new sanding sheet with finer grit
Scratches on workpiece after
sanding
Not enough material removed Continue sanding
Sanding sheet incompatible with material Fit correct sanding sheet
Burn marks on workpiece
Too much pressure exerted on to the sander Use less pressure whilst moving the machine
Dust extraction not working; sanding sheet not aligned
with dust extraction holes in the Hook & Loop Sanding Realign sanding sheet; unblock dust extraction holes
Base (1); extraction holes blocked
Excessive dust emission
Dust Bag (5) full Empty Dust Bag
Dust Bag insufficient for the task at hand Connect a vacuum dust extraction system
8