Exibel Swivel Wall Bracket Bedienungsanleitung Seite 5

Mounting
Warning:
Make sure that the wall you intend to attach the wall bracket to can bear
the combined weight of the bracket and TV. If you are unsure, contact a tradesman.
Make sure that you test the capacity of the bracket with a load of equal weight as
the TV before mounting the TV onto it.
Screwing the wall bracket to the wall
1. Remove the rear cover of
the wall bracket.
a) Remove the two nuts
holding the mounting plate
to the wall bracket.
b) Lift the mounting plate and
unhook it from the bracket.
2. Screw the wall bracket to the wall. Use a spirit level to ensure that the bracket
is level.
Brick or concrete wall
Measure, mark out and
drill the mounting holes.
Use a hammer drill.
Drill the mounting holes 80 mm
deep using a Ø 10 mm (3/8")
drill bit. Hammer the accompanying
wall plugs into the holes.
Important! The holes must be
at least as deep as the length of
the screws.
Note: Make sure that the entire
plug grips the concrete, use
longer screws if necessary.
Correct Incorrect
5