Epson EMP-TW10H dreamio Bedienungsanleitung Seite 24

Appendices
fLamp replacement period
• It is time to change the lamp when the "Replace the lamp" message appears
in the bottom left hand corner of the screen at the commencement of
projection and remains for 30 seconds.
• It is also time to change the lamp when the Warning indicator flashes red at
0.5 second intervals.
• The time when the replacement message appears varies depending on the colour mode which has been used.
p
If Theatre Black has been used continuously: About 2900 hours
If other modes have been used continuously: About 1900 hours
• When this message is displayed, please replace the lamp as quickly as possible.
• The lamp may explode if you continue to use it beyond the lamp replacement period.
• Some lamps may stop operating before the replacement message is displayed. It is recommended that you have a
replacement lamp ready in case this happens.
• Replacement lamps can be purchased at your nearest dealer.
fReplacing the lamp
(Spare lamp: ELPLP29)
• Wait until the lamp has cooled down sufficiently before opening the lamp cover. It takes a further one hour after the cool-
c
down period has finished for the lamp to be cool enough.
• When the lamp is broken, replace it with a new lamp, or contact your dealer for further advice. If replacing the lamp
yourself, be careful to avoid pieces of broken glass.
1
Turn off the projector and wait for the
cool-down period to end. (Approx. 20
seconds)
Remove the power cable and wait for the
lamp to cool down. (Approx. 1 hour)
2
Open the lamp cover.
Lift the lamp cover by putting your fingers in
the latches and lifting upwards.
3
Loosen the fixing screws holding the
lamp in place.
22
-Projector Care
4
Remove the old lamp.
5
Install the new lamp.
Press the lamp until it clicks into place, then
tighten the two fixing screws.
6
Replace the lamp cover.
First insert the tabs, and then press down on
the opposite side until it clicks into place.
http://www.pureglare.com.au