NSK Ti-Max nano65LS Bedienungsanleitung Seite 11

6-2 Cleaning (Optic)
Wipe clean the Glass Rod tip with an alcohol-immersed cotton swab. Remove all debris and oil. (Fig.5)
CAUTION
Do not use a sharp tool to clean the Glass Rod. It could damage the glass and reduce the light
transmission.
6-3 Lubrication
NSK PANA SPRAY Plus
Apply NSK PANA SPRAY Plus every time after each use and/or before autoclaving.
1) Remove the bur from the handpiece.
2) Insert the Spray Nozzle into the Spray Port nozzle on the can.
3) Insert the Spray Nozzle in rear of the handpiece. Hold the handpiece and spray for approximately 2-3
seconds. Apply lubricant until it expels from the handpiece head for at least 2 seconds. (Fig.6)
10
Cotton Swab
Glass Rod Optic
Fig. 5
E-Type Spray Nozzle
Handpiece
Fig. 6