Specification; Troubleshooting - NSK ULTIMATE XL-F Bedienungsanleitung

11. Specification
Control Unit
Model NE230
AC120V 50/60 Hz 46VA
Power supply
AC230V 50/60 Hz 46VA
Rated Power 46VA
Weight 3.8kg
Dimensions W230x D292x H113mm
Motor Handpiece
1) Torque Type
UMXL-T ( P ) / UMXL-T ( P ) 2M
Model
Speed 1,000~40,000 min
Max. Torque 8.7 N · cm
Weight 215g (exclude the cord)
Dimensions L151x
Cord Length 2.0m

12. Troubleshooting

Please check the following points before sending back instruments for repair.
(Unit / Motor)
Trouble
The Power Indicator
does not light up.
The power
indicator flashes
when the pedal
is depressed.
-1
29mm
Cause/Check
Check that the power plug is
connected.
Check that the fuse has not burnt
out.
Check the power switch for
malfunction.
The power indicator soon starts
flashing even though the pedal is
depressed.
The motor handpiece sometimes
starts turning if the pedal is
depressed several times.
The motor handpiece starts
turning immediately when the
pedal is depressed.
Handpiece Stand
Model Handpiece Stand
Weight 120g
2) Compact Type
Model UMXL-C 2M
Speed 1,000~40,000 min
Max. Torque 6 N · cm
Weight 181g (exclude the cord)
Dimensions L144 x 27mm
Cord Length 2.0m
Insert the power plug correctly.
Replace it with a specified fuse. If the
reason the fuse has blown is unknown,
ask for an inspection.
Ask for repair.
If the signal from the motor is not
transmitted to the unit, a problem will
occur. Check the motor cord again to
determine if it is damaged and is
connected correctly. If the motor cord
is damaged or the cause is not
determined, please ask for repair
service.
The trouble could be from the brake
circuit. Please ask for repair service.
The problem could be due to the
excess current in the detection of the
circuit. Stop operating the motor for a
while.
11
-1
Remedy