Stobag SRCK 630 Gebrauchsanleitungen Seite 28

ENGLISH
7 -
You must set the of the climatic sensors, i.e. a value above (or below) which the sensor trips and sends a wire-
less command to the receiver in which it is memorized.
(fig. 5
When the windspeed drops below the setpoint, after 4 minutes the sensor sends a signal to the motor, thus releasing it to
(fig. 6
the sensor sends the Down command to the motor.
(fig. 7
to Down. Refer to the motor manual). Manual commands can be sent at any time.
(fig. 8)
01.
02.
disables the Sun sensor.
03.
04. Restore power to the sensor.
05.
06. To terminate the procedure, wait for the flashing to stop.
28
Important
8 -
the setpoint values and to identify malfunctions.
- Table A. Note
wind and rain together), the diagnostics signals only the one which has the lower number in Table A .
Note
Table A
Red Led on
1
has been exceeded
Orange Led on
2
setpoint has been exceeded
Green Led on
3
setpoint has been exceeded
Red Led flashing
seconds) Self-test: wind sensor fault. The
4
sensor has not detected variation in the wind
Orange Led flashing
Self-test: rain sensor fault. The
5
days
Green Led flashing Self-test:
6
sun sensor fault. The sensor has not detected
7
Led off
www.stobag.com