Initial Use - Princess 333832 Bedienungsanleitung

Congratulations!
You have purchased a Princess product.
Our aim is to provide quality products with
a tasteful design and at an affordable price.
We hope that you will enjoy this product for
many years.
Description (fig. A)
Your 333832 Princess garment steamer has
been designed for steaming garments and
fabrics to remove creases. The appliance is
suitable for indoor use only. The appliance is
suitable for domestic use only.
1. On/off switch
2. On/off indicator
3. Steam indicator (garment steamer)
4. Steam hose
5. Steam head
6. Steam button
7. Steam indicator (steam head)
8. Telescopic pole
9. Pole connection
10. Locking knob (telescopic pole)
11. Clamps (telescopic pole)
12. Water reservoir
13. Water filling point
14. Water drain point
15. Wheels
16. Clothes hanger
17. Clothes hanger attachment
18. Steam head holder
19. Fabric brush
20. Crease attachment

Initial use

• Clean the appliance. Refer to the section
"Cleaning and maintenance".
Assembly (fig. A & B)
Before you proceed, we need you to pay
attention to the following notes:
- Before assembly, switch off the appliance,
remove the mains plug from the wall
socket and wait until the appliance has
cooled down.
- Make sure that the telescopic pole is fully
extended to provide a free flow of steam.
• Place the water reservoir (12) into the
appliance.
• Insert the telescopic pole (8) into the pole
connection (9). Turn the locking knob (10)
clockwise to lock the telescopic pole (8).
• Release the clamps (11). Set the telescopic
pole (8) to the maximum height. Lock the
clamps (11).
• Assemble the clothes hanger (16) as shown
(fig. B). Tighten the clothes hanger (16)
onto the telescopic pole (8).
• If necessary, mount the clothes hanger
attachment (17) to the clothes hanger (16)
as shown (fig. B).
• Hang the steam head (5) onto the steam
head holder (18).
Use
Filling the water reservoir (fig. C)
Before you proceed, we need you to pay
attention to the following notes:
- Before filling the water reservoir, switch off
the appliance, remove the mains plug from
the wall socket and wait until the appliance
has cooled down.
Before you proceed, we would like you to
focus your attention on the following notes:
- Do not use the appliance without water
in the water reservoir.
- Do not exceed the maximum mark when
you fill the water reservoir. Make sure that
the water level is always above the minimum
mark.
- It is recommended to fill the water reservoir
with a mixture of 50% tap water and 50%
distilled water in order to prevent the
formation of excessive limescale.
- Only use cold water to fill the water
reservoir.
- Do not use carbonated water or other
liquids to fill the water reservoir.
• Remove the water reservoir (12) from the
appliance.
• Remove the cap (21).
• Fill the water reservoir (12) through the
water filling point (13) with the required
amount of water.
11