English
Application
Siedle Axiom: video indoor call sta
tion and telephony in one device.
Electrical voltage
Mounting, installation and servicing
work on electrical devices may only
be performed by a suitably qualified
electrician.
Electrostatic charging
As a result of electrostatic charging,
direct contact with the circuit board
can result in destruction of the
device. Direct contact with the circuit
board must therefore be avoided.
Static magnetic field
Magnetic fields can pose a hazard
for pacemakers, magnetic data
storage media and electronic
devices. A safe distance must be
maintained.
Battery safety
The DECT™ receiver contains a non
removable battery (LiPo; 3,7 V
500 mAh), therefore the general
battery safety instructions apply.
• Keep the battery away from
sources of heat and naked flames.
• Never immerse the battery in
liquids.
• Never attempt to dissemble or
modify the battery, or to expose it to
the effects of heat.
• Avoid dropping the battery and
protect it from jolting and impacts
which could damage the housing.
• Otherwise there is a risk of explo
sion or battery leakage, which could
result in fire, injury or damage to the
surroundings.
• If a battery leaks and the emerging
substances come into contact with
the eyes, mouth, skin or clothing,
rinse the affected area immediately
using water and consult a doctor.
• Only use the holder provided to
charge the battery in the receiver.
• The holder was developed exclu
sively for use with the receiver.
Do not use with other products or
storage batteries.
• A risk of overheating and defor
mation exists which could cause fires
or initiate electric shocks.
For technical reasons, rechargeable
batteries lose their charging capacity
as they age, and the risk of a mal
function or even device failure also
increases. It is therefore advisable
to replace rechargeable batteries
with new ones after many years of
use, when their performance – such
as the maximum duration of a call
– has noticeably dropped. Siedle is
happy to answer any questions you
may have and assist with implemen
tation.
The receiver must not be opened.
To replace the rechargeable battery,
please send the receiver to us.
To protect rechargeable energy
storage devices and prolong their
service life, devices with lithium
batteries fitted should be charged
regularly. However they should not
be permanently connected to the
charging cradle.
The location for devices with a
lithium battery should be selected
so that there is sufficient clearance
from potential fire loads.
Once the device has cooled down
significantly, it should not be put
into operation until it has reached
room temperature.
When using battery-operated
devices outside, avoid overheating
due to prolonged exposure to sun
light. These devices must not be
charged in a heated state.
The lithium battery must be
replaced/a replacement arranged
for all devices that switch off after
a short period of low use when not
on the charging cradle due to low
stored energy.
Safety remarks
• Modern furniture is coated with an
enormous variety of different lacquer
and plastic finishes. Constituents of
these materials can result in sof
tening of the plastic feet in tabletop
devices and so impair the surface of
the furniture. Please appreciate that
the manufacturer is unable to accept
any liability.
• Avoid sources of interference such
as microwave devices or electrical
devices with large metal housings in
the vicinity of the base station.
• For any servicing requirements,
please contact your specialist dealer
or electrical installer.
• When using in conjunction with a
hearing aid, it is possible for hum
ming or feedback noises to occur.
• The cordless handset and the base
station should be positioned at least
1 metre distant from other electrical
devices.
• When used close to medical
devices, functional disturbances can
occur. In such cases, please contact
the manufacturer.
• In the case of a tabletop device,
ensure the device is securely sup
ported. Lay the cables safely to pre
vent trip hazards.
Scope of supply A 180-10
(Wall version without receiver)
• Siedle Axiom
• Wall mounting plate
• RJ45 socket
• A BLT 251-0 bus licence telephony
• Operating instructions for the end
customer
• This product information
7