mspa P-MB06 MONT BLANC Bedienungsanleitung Seite 6

● Do not attempt to plug in or unplug this product while standing in water or when
your hands are wet.
● Do not use the spa if damaged in delivery and/or malfunctioning in any way.
● Contact the MSpa service center for further direction.
● Keep all pets away from the spa to avoid any damage.
● Do not add bath oil or bath salt to the spa water.
● Always add chemicals to water, never add water to chemicals. Adding water to
chemicals may cause strong fumes or violent reactions and hazardous chemical
spray.
● For water already used, discharge it in time or use water chemicals for cleaning.
Usually,change water every 3-5 days.
● Use Mspa chemical kit for disinfection in accordance with manufacture's
instructions.
● Do not leave or set up the spa in temperature lower than 4°C(39°F) if heater is
not operating.
● Always enter and exit the spa or hot tub slowly and cautiously. Caution of wet
floor.
● To avoid damage to the pump, never turn on the spa or hot tubs unless it is
filled with water to the minimum water line.
● Place the spa or hot tub only on a properly prepared site that can withstand the
floor loading requirement of the spa.
● Do not leave the spa empty for extended period of time. Drain away water
inside the pool thoroughly for long time disuse. Do not expose the spa under
direct sunshine. Check regularly before each use. Put away the spa or fence it
up in time after using.
● Open the spa top lid when the Bubble function is on.
● In order to avoid a hazard due to inadvertent resetting of the thermal cut-out,
this appliance must not be supplied through an external switching device, such
as a timer, or connected to a circuit that is regularly switched on and off by the
utility.
● Refer to relevant chapter for details concerning cleaning and other
maintenance.
! CAUTION
6