Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
7
Cutting procedure
During cutting, place the blade
guard as close as possible to the
tile, in order to avoid water
splash.
• Straight cuts
- Raise the two clips at the ends of the
guide (fig 4).
- Position the cutting guide
- Lower the two clips
- Slacken off the two nuts (fig 5).
- Adjust the movable part of the guide.
- Tighten the two nuts.
• Diagonal cuts
- Place the accessory in position on the
movable part of the guide.
- Slide the guide and the material toge-
ther.
• Bevel cuts
- Slacken off the two side nuts (fig. 6).
- Lean the motor over to the cutting angle
required (from 90° to 45°).
- Tighten the two nuts.
- Adjust the cutting guide as for vertical
cuts.
- Hold the material firmly and advance it
steadily.
- Towards the end of the cut, do not push
too hard.
• Pass the material slowly and without
force, through the diamond blade.
• This will ensure a greater lifetime of the
blade and avoid overheating of the motor.
Never cut dry. Check frequently
the water level through the over-
flow (change water as often as
necessary)
• After each use, stop the machine by
means of the on - off switch.
12
8
Maintenance
(machine disconnected)
• Remove the tank (fig 7).
• Empty the tank.
• Clean the machine daily, keeping the
water compartment clean.
• Store in a dry place.
Store in a safe place
Maintain tools carefully
9
Important advice
• Tighten all the nuts and bolts regularly.
• Check that there is sufficient water sup-
ply during operation.
• Tighten the blade firmly.
• A plastic/polypropylene water tray is
recommended.
The manufacturer declines all
responsibility for loss or damage
resulting from misuse or any
modification, alteration or powe-
ring that does not conform to the
manufacturer's original specifica-
tions.
At the work station, the sound
pressure level may exceed 85 db
(A)
In this case individual protection
measures must be taken.
10
Repairs
Contact your supplier who is enti-
S
rely at your service to carry out
A
V
repairs in the shortest time at the
best possible price.
11
Spare parts
For rapid delivery of spares and in order to
avoid any wasted time, it is necessary to
remind your supplier of the details shown
on the instruction plate on the machine with
each order, as well as the reference of the
part to be replaced.
00000000
(0)
Item number
See exploded view
12
Scrapping
In the event of deterioration and
scrapping of the machine, the fol-
lowing items must be disposed
of in accordance with the requi-
rements of the legislation in
force.
• Main materials :
- Motor : Aluminium (AL) - Steel (AC),
Motor :
Copper (CU) - Polyamide (PA)
- Machine : Aluminium (AL) - Inox
The instructions for use and spare parts found in
this document are for information only and are not
binding.
As part of our product quality improvement policy,
we reserve the right to make any and all technical
modifications without prior notice.
Quantity
8
Werbung
Inhaltsverzeichnis
