Tip Protector; Transporting The Scooter; Using Ramps; Maintenance - Vermeiren Carpo 3 Gebrauchsanweisung

TIP PROTECTOR

TRANSPORTING THE SCOOTER

If your scooter is to be transported, please note the following:
Before picking up the scooter all movable parts must be removed (basket, armrests, etc.). You could
also remove the batteries / battery boxes from the seat to save weight.
As gel batteries are closed battery systems, removal for the purpose of transportation will cause no
problem.
L
When raising the scooter, it should be held by fixed parts of the frame only.
L
To prevent damage, all loose parts should be removed prior to transportation.
L
When assembling, make sure that all screws are retightened properly.
L
To prevent personal injury or damage to the scooter, there should be no people or objects
under the scooter during transportation.
L
Likewise, there must be no people or objects on the foot rests or seat during transportation.

USING RAMPS

Should you wish to use ramps to drive over an obstacle, please note the following:
For your own safety, find out from the manufacturer what the maximum load is that the ramps can
bear. Drive on the ramps at the lowest speed possible. Also see the instructions in chapter "Your first
trip with the scooter".
If another person is pushing you, note that the considerable weight of the electric scooter generates
large reverse forces.
L
Observe the instructions on the maximum load of the ramps used.
L
We shall decline all liability for injury or damage caused by an improper choice of ramps.

MAINTENANCE

For the maintenance manual of the scooters refer to the Vermeiren website: www.vermeiren.com.
SCOOTER Instruction Manual
A tip protector fixed to the frame is part of the
standard equipment. It is thus not possible to
remove it. The tip protector is there for your safety.
It prevents the scooter from tipping over backward
when you drive over small obstacles that do NOT
exceed the maximum height specified.
Last updated: 2018-07
9