M-system MFCD 95 series Gebrauchsanweisung Seite 190

C)
GAS CONNECTION
FR
Cat:
The gases used for the operation of
cooking appliances may be grouped by
their characteristics into two types:
- Liquefied gases: Butane Gas (G30) and
Propane Gas (G31)
- Natural Gas (G20 / G25)
The fitting (fig. 9.7) is made up of:
A - Gas train terminal fitting (rh or lh)
B - Gasket
Before the connection remove the conical
connector B if fitted (fig. 9.3).
IMPORTANT:
To fix the gas pipe it is necessary to
operate with 2 spanners (fig. 9.9).
After connecting to the mains, check
that the couplings are correctly sealed,
using soapy solution, but never a
naked flame.
A
B
a
190
II
2E+3+
FR
Fig. 9.7
b
Fig. 9.8
Appliances which can be built in
2/1)
For gases supplied by a pipe, the
connection can be made using one of
the following:
•
a rigid pipe with screw-nut;
•
a metal corrugated flexible hose
according to NF D 36-121 (fig. 9.8a);
•
a flexible hose with mechanical ferrule
according to NF D 36-103 or D 36-100
(fig. 9.8b);
For butane-propane distributed by
cylinder or tank, the connection is
made using one of the following:
•
a rigid pipe with screw-nut;
•
a metal corrugated flexible hose
according to NF D 36-125 (fig. 9.8a);
•
a flexible hose with mechanical ferrule
according to XP D 36-112 (fig. 9.8b);
Access must be possible to the full length
of flexible tubes. They must be replaced
before their final date of use (marked on
the hose) and must be a maximum of 2 m
long.
Note: In France, use a tube bearing the
mark NF GAZ.
(class
Fig. 9.9