Additional template table adjustments can also
be made using both handwheels of your GE 70.
Caution! Of course the position of the template
may no longer be changed during the engraving
process.
When aligning the work piece, please
observe:
The work table moves in the opposite direction
of the moving direction of the guide marker in
the grooves of the digit and letter blocks, as
shown in Diagram 9.
Engraving
1. Insert the guide marker in the groove of the
desired digit and letter plate
2. With the handwheel for the milling cutter
height adjustment, lower the milling cutter to
a position just above the work piece.
3. Switch on the milling cutter
4. With the handwheel for the milling cutter
height adjustment, lower the milling cutter to
the desired position
5. Engrave the digit, or letter
6. Move the milling cutter out of the work piece
with the handwheel for the milling cutter
height adjustment
7. Repeat the operation for every digit and
letter
- 9 -