Herunterladen Inhalt Inhalt Diese Seite drucken
Vorschau ausblenden Andere Handbücher für Aquatec ORCA:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 31
Aquatec® ORCA / ORCA F / ORCA XL
IMPORTANT!
If the battery in the hand control C is not
sufficiently charged, the red indicator lamp E
lights up red when the Down button D is pressed.
In this case, the lowering function of the bath lift
is disabled. You can however still raise the lift.
– Recharge the battery immediately after raising
the bath lift.
Raising the bath lift
IMPORTANT!
If the backrest is lowered, it will move into the
upright position first (not on model ORCA F).
1. Press the Up button B on the hand control and keep it
pressed.
The backrest moves into the upright position or the
seat moves upwards.
2. Release the Up button on the hand control.
The bath lift stops in the current position.
Lowering the bath lift
IMPORTANT!
If the seat is already lowered, the backrest lowers
towards the rear (not on model ORCA F).
1. Press the Down button D on the hand control and
keep it pressed.
The seat moves downwards or the backrest tilts to the
rear.
2. Release the Down button on the hand control.
The bath lift stops in the current position.
16
Emergency off switch
IMPORTANT!
Only press the Emergency Off button A if the
device does not stop immediately when the Up or
Down button is released (e.g. if a button jams).
The bath lift stops moving immediately and the
red light integrated in the hand control lights up.
If the red indicator light switches off after the emergency off
button is released, the fault has been rectified (e.g. button
is released again). The device is ready to use again.
If the red indicator light stays on after the emergency off
button is released, the fault has not yet been rectified. The
device is not ready for use and must be repaired, e.g. in the
event of damage to the electronics.
Contact your specialist dealer, if necessary.

4.3 Bathing

WARNING!
Risk of slipping
The bath lift can slip if the suction cups do not
have a good hold.
– Before using the bath lift ensure that it is
securely positioned and cannot tip over.
– Ensure that the bath lift is set up in the
bathtub, → 3.3 Setting up the bath lift, page
10.
1574469-C

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Aquatec orca xlAquatec orca f

Inhaltsverzeichnis