Temperature Indicator - Sharp SJ-T1435E0W-EU Bedienungsanleitung

CHAPTER -3: USING YOUR FRIDGE FREEZER

Temperature indicator

In order to help you better set your refrigerator, we have equipped it with a temperature indicator located in
the coldest area.
To better store the food in your refrigerator, especially in the coldest area, make sure the message "OK"
appears on the temperature indicator. If "OK" does not appear, this means that the temperature setting has
not been done properly.
Since "OK" appears in black, it will be difficult to see this indication if the temperature indicator is badly lit. To
be able to see this indication properly, there should be enough light.
Each time the temperature setting device is changed, wait for the stabilisation of the temperature inside the appliance
before proceeding, if necessary, with a new temperature setting. Please change the position of the temperature setting
device progressively and wait at least 12 hours before starting a new check and potential change.
NOTE: Following repeated openings (or prolonged opening) of the door or after putting fresh food into the appliance, it
is normal for the indication "OK" not to appear in the temperature setting indicator. If there is an abnormal ice crystals
build-up (bottom wall of the appliance) on the refrigerator compartment evaporator (overloaded appliance, high room
temperature, frequent door openings), set the temperature setting device to a lower position until compressor off
periods are obtained again.
Putting food in the coldest area of the refrigerator
Your foods will be better stored if you put them in the most appropriate
cooling area. The coldest area is just above the crisper.
The following symbol indicates the coldest area of your refrigerator.
To ensure a low temperature in this area, make sure the shelf is located at
the the same level as this symbol, as shown in the illustration.
The upper limit of the coldest area is indicated by the lower side of the sticker (head of
the arrow). The coldest area upper shelf must be at the same level with the arrow head.
The coldest area is below this level.
As these shelves are removable, make sure they are always at the same level with these
zone limits described on the stickers, in order to guarantee temperatures in this area.
Accessories
Icematic
• Take out the ice making tray
• Fill the water to the line.
• Place the ice making tray in its original position
• When ice cubes are formed, twist the lever to drop ice cubes into the icebox.
Note:
• Do not fill the icebox with water in order to make ice. It may be broken.
• The movement of the ice maker may be difficult while the refrigerator is running. In such a case, it should be
cleaned after removing the glass shelves.
Removing the ice maker
• Take out the glass shelves of freezer compartment
• Remove the icemaker by moving it to left or right on the shelf.
You can remove the icemaker to create a larger volume of the freezer compartment.
Chiller shelf
• Pull the chiller shelf out toward you by sliding it on rails.
• Pull the chiller shelf up from the rail to remove.
After the chiller shelf has been removed, it can support a maximum 20 kg load.
Keeping food in the chiller compartment instead of the freezer or refrigerator
compartment allows food retain freshness and flavour longer while preserving its fresh
appearance. If the chiller tray becomes dirty, remove it and wash with water.
(Water freezes at 0 °C, but foods containing salt or sugar require lowered temperatures
to freeze)
Normally people use the chiller compartment for raw fish, rice, etc...
Do not put foods you want to freeze or ice trays in order to make ice.
Removing the chiller shelf
EN -10-
OK