Panasonic ER-GK60 Bedienungsanleitung Seite 14

3. Wipe off the water with a towel and
let it dry naturally.
• It will dry faster with the blade
removed.
4. Apply the oil to the blade after
drying. (See this page.)
5. Attach the blade and attachment to the main body.
►With the brush
Main body and blade
• Remove the blade. (See this page.)
1. Brush off any hair trimmings from the
main body and from around the blade.
2. Brush off the hairs from the blade edge.
3. Brush any hair trimmings out from
between the stationary blade and the
moving blade while pressing down the
cleaning lever (a) to raise the moving
blade.
4. Apply the oil to the blade. (See this page.)
5. Attach the blade and attachment to the main body.
AC adaptor
Use the cleaning brush to clean hair trimmings and dust in the
charging plug or in the hole on the bottom surface.
14
ER-GK60_EU.indb 14
Lubrication
• Apply the oil to the blade before and after each use.
1
Remove the blade.
2
Apply a drop of the oil to
each indicated point.
3
Attach the blade to the main
body, turn on the power and
allow to run for
approximately 5 seconds.
► Replacement parts
Replacement part is available at your dealer or Service Centre.
Replacement parts for ER‑GK60

Removing and mounting the blade
Removing the blade
Hold the trimmer and push the blade
with your thumb.
Mounting the blade
Fit the mounting hook (B) into the blade mounting (A) on the
trimmer and then push in until you hear a click.


Blade WER9500
2017/04/13 9:18:24