Avintage AVU18CDZA Gebrauchsanweisung Seite 40

1. Lower hinge (right)
4. Door
7. Top hinge (left)
10. Door limit device
1. Open the door to 90 degrees, remove the two screws (2) from the lower door axis (3), remove the door
(4) and door axis (Fig. A).
2. Position the door (4) safely and remove the plug (12) from the top of the door frame. Unscrew one
screw (11) at the bottom and remove the door limit device (10). Install the door limit device (10) at the
top of the door frame. Please use the spare plug (12) to block the hole at the top of the door frame
(Fig. A/B).
3. Take out three hinge screws (6) from the upper hinge (right) (5) and remove it (Fig. C).
4. Remove the decorative nail (8) from the top left of the cabinet and install the spare top hinge (left) (7)
on the top left of the cabinet with three screws (Fig. D).
5. Install the spare lower hinge (left) (9) according to the above procedure (Fig. E).
6. The door opens to 180 degrees. Install the door in the same way as it was removed and fix it so that
the door is aligned.
7. Block the hole at the top right of the cabinet with the spare decorative nail (8).
4. OPERATING INSTRUCTIONS
It is recommended that you installed your appliance in a place where the ambient temperature is
between 16-38°C. If the ambient temperature is above or below recommended temperatures, the
performance of the unit may be affected and it may not be possible to obtain temperature between 10-
20°C/5-10°C.
 "RUN"
Power indicator.

button
To turn the appliance on or off.
Press and hold this button for around 3 seconds.

button
Inner lighting control button.
 Left electronic display
Display the set temperature in lower compartment.
 Right electronic display
Display the set temperature in upper compartment.
2. Screws
5. Top hinge (right)
8. Decorative nail
11. Screw
3. Door axis
6. Hinge screws
9. Lower hinge (left)
12. Plug
40