Operation - Klarstein 10033020 Bedienungsanleitung

OPERATION

1 Put the clean food in the trays – Do not overload the trays and never overlap the
food. Close the damper door.
2 Plug dehydrator into wall outlet. There is a beep sound at the beginning, and the
four indicator lights up. The LED screen will show "00:00".
3 Set the temperature
Press the "TIME/TEMP" button, The LED screen will show default time setting
"70°C".
Press the "+" or "-" buttons to select the desired temperature. To change the
temperature rapidly, hold down the "+" or "-" buttons. The temperature can be
changed between the range of 35–70°C.
4 Set the time
Press the "TIME/TEMP" button and the "10:00" will begin to flash.
Press the "+" or "-" , buttons until the desired time is displayed. If you hold down
the "+" or "-" buttons, the time will change rapidly. The timer can be set between
"00:30" and "19:30".
5 After the temperature and time have been set, press the "TIME/TEMP" button firstly,
then press the "START/STOP" button, the dehydrator will start to work. The motor
and fan will start initially, with the heating element starting 5 seconds later. The set
time will begin to count down, and the ":" symbol on the LED screen will flash.
Note: Set low temperature for thin/small pieces of food or for a small load of
food. Set high temperature for drying thick/big pieces of food and large loads. The
thermostat can also be used to decrease the temperature as the food is near the end
of its drying cycle making it easier to control the final moisture level in the food.
6 In standby mode
You can press the "TIME/TEMP" button firstly, then press "START/STOP" button,
to get into default mode to start work (TIME: 10:00, TEMP: 70°C) . You also can
change the drying time and temp if needed.
Change the Time during drying process:
7
When the LED screen shows the time, Press the "+" or "-" button directly to change
the setting time.
EN
19