Important Information; Mounting Instructions - Duravit SensoWash Slim Montageanleitung

Important information

Mounting instructions information
These mounting instructions come as part of
the Duravit shower toilet and should be read
carefully prior to in-stallation.
explanation of the key words and symbols
Indicates a hazardous
danger
situation which, if not avoided,
will result in death or serious
injury.
Is used to address practices
notice
not related to physical injury
Link to the mounting information in
this section
target readership and qualifications
The shower toilet and associated water
connection should only be installed by
qualified plumbers. The electrical installation
should only be carried out by qualified
electricians.
risk of product and/or
notice
property damage!
> Observe the local installation regulations
and any country-specific standards at all
times.
risk of product damage due
notice
to freezing water!
> Do not install the shower toilet in rooms at
risk of frost. The room temperature must
not be less than 4 °C.
risk of product damage due
notice
to condensation!
> Leave the unit switched off for a few hours
if it has previously been moved from a cold
location to a warm location.
SensoWash Slim_MAL_56940/15.07.3
Safety instructions
danger
risk of fatal electric shock!
> Do NOT remove individual shower toilet
components.
> If the supply cord on this unit is damaged, it
must be replaced by the manufacturer, the
service agent or similarly qualified persons
in order to avoid a hazard.
> Appliances have to be correctly earthed.

Mounting instructions

Please read pre-installation information
sheets prior to the installation. These are
available to download on the Internet at
www.duravit.com.
An installation video of the complete shower
toilet is available at duravit.com/mnt_sewa_
slim.
Simply use
this QR code
checking the installation requirements
1
(diagram 1)
The installation of the WC ceramics with
pre-installation of the shower toilet water
and power supplies is described in sepa-
rate instructions.
> Ensure that the supplies and WC ceram-
ics have been installed and mounted
according to the instructions and
regulations.
Positioning the metal bracket
19
(diagram 19)
> Continue with step 22 for screw
mounting.
> Follow the instructions up to step 21
for mounting with adhesive and then
continue with step 26.
5