Important Notes; Notes On Operating Instructions; Intended Use - Mettler Toledo InPro 6000 Bedienungsanleitung

6
2

Important notes

2.1

Notes on operating instructions

These operating instructions contain all the information
needed for safe and proper use of the optical sensor.
The operating instructions are intended for personnel
entrusted with the operation and maintenance of the
sensors. It is assumed that these persons are familiar
with the equipment in which the sensor is installed.
Warning notices and symbols
This instruction manual identifies safety instructions
and additional information by means of the following
symbols:
This symbol draws attention to safety instructions and
warnings of potential danger which, if neglected,
could result in injury to persons and / or damage to
property.
This symbol identifies additional information and
instructions which, if neglected, could lead to defects,
inefficient operation and possible loss of production.
2.2

Intended use

METTLER TOLEDO optical O
solely for inline measurement of the oxygen partial
pressure, as described in this instruction manual.
Any use of these sensors which differs from or exceeds
the scope of use described in this instruction manual
will be regarded as inappropriate and incompatible
with the intended purpose. The manufacturer / supplier
accepts no responsibility whatsoever for any damage
resulting from such improper use. The risk is borne en-
tirely by the user / operator.
Other prerequisites for appropriate use include:
– compliance with the instructions, notes and
requirements set out in this instruction manual.
– acceptance of responsibility for regular inspection,
maintenance and functional testing of all asso -
ci ated components, also including compliance
with local operational and plant safety regulations.
– compliance with all information and warnings
given in the documentation relating to the products
used in conjunction with the sensor (housings,
transmitters, etc.).
– observance of all safety regulations governing the
equipment in which the sensor is installed.
– correct equipment operation in conformance with
the prescribed environmental and operational
conditions, and admissible installation positions.
– consultation with Mettler-Toledo Process Analytics
in the event of any uncertainties.
InPro 6000 optical O
52 206 256
InPro 6000 Series Optical O
sensors
2
Sensors 12 mm
2
sensors are intended
2
© 07 / 12 Mettler-Toledo AG
Printed in Switzerland