Installation Instructions - Eneo MPC-52C0000M0A Betriebsanleitung

CAUTION:
The camera has a built-in 1/2.8" sensor so using a quali ed 1/2.8"
C/CS mount lens is recommended.
Some unquali ed lenses may have a smaller image circle even if
the speci cation is 1/2.8" so it may cause vignetting on the video.
Please ensure the correct image circle size of the lens before
installation to prevent vignetting on the video.

Installation instructions

CAUTION:
The camera's mounting accessory should be attached to a
structural object, such as concrete, hard wood, wall stud or
ceiling rafter that supports the weight of the camera.
If necessary use appropriate mounting material (e.g. anchors)
instead of the material enclosed with the camera.
• Make sure the power is removed before the installation.
• Follow the order for applying power.
Camera can work with either 24VAC or 12VDC, dual voltage power. Primary and secondary
grounds are completely isolated to avoid the possible ground-loop problems. First
connect the low voltage (DC12V or AC24V), then plug the AC adapter to AC outlets to
avoid an improper reset from power jitter and a damage from the surge voltage when no
load.
1. Remove the dust protection cap from the lens mount.
2. Screw the lens onto the camera rmly.
3. Plug the lens plug into the lens connector on the side of the camera case.
4. Mount the camera to the wall or ceilling with a corresponding mounting bracket
through the camera mount holes (1/4" thread insert) on its top or bottom.
CAUTION:
Care should be taken the cable is NOT to be damaged, kinked
or exposed in the hazardous area.
Do not expose the camera directly to a strong light source such
as the sun or spot light.
EN
7