Leister WELDPLAST S1 Bedienungsanleitung Seite 26

Working display overview
Startup display
Display on startup with the
software release of the output
unit.
Cool down mode
In this mode, the heating is
switched off and the device
is in cool down mode. If the
pre-heating air temperature
is more than 100°C when
the device is switched
on, the device switches
automatically to «Cool down
mode». The cooling process is complete when
the pre-heating air temperature has been below
100°C for 2 mins.
To switch the heating back on again, press the
«Heating on/off » key (23)
med» key (25)
Maintenance servicing
When the maintenance
interval for the drive motor
is reached, «Maintenance
Servicing» appears after
the startup display. You can
carry on working by pressing
the «Confi rmed» key (25)
. You must take the
device to your service center.
Start display
The start display shows all
setpoints.
At this point, the heating is
not switched on but you can
set all setpoints.
26
or the «Confi r-
.
Welding startup display
Display during the heating
process
Select Profi le
Select a user-defi ned profi le
or one defi ned by Leister. The
process of selecting a profi le
is described in detail in the
«Select Profi le» chapter on
page 32.
Setup
In the basic setting, you can
save profi les and access
the standby function via the
«Setup» menu.
Select «Advanced Mode»
to access a range of other
settings options.
Save profi le
The process of saving freely
defi nable profi les is described
in detail in the «Defi ning
profi les» chapter on page
34/35.