Velleman CTC1000 Bedienungsanleitung Seite 27

1. Enter your pin code and press OK. The display shows:
2. The cursor blinks next to Away Arm. Press OK. The display shows:
The control panel starts the countdown and plays a sound.
o
(The sound and actual exit time depend on your settings, see 7.9.)
When the countdown time is up, the system will play a long sound and the system will be armed.
o
Notes
 The control panel has a screen saver function. The Alarm ON message will be displayed for 180 seconds.
After that, the display shows only current date and time.
 If the Final Door Set Option is set to ON, the control panel will enter Alarm On mode as soon as the door
has been closed.
 If a door contact or PIR sensor has been triggered (for example a door is still open), you cannot arm the
system. To arm the system anyway, see section Force arming the system below.
 The system can also be armed with the (optional) remote control.
Stopping the exit delay
When you have armed the system and the countdown timer is still running, the exit delay can be stopped by
disarming the system.
1. Press key.
The screen will ask you to enter the pin code.
The counting down delay is displayed on the control panel.
2. Enter your pin code and press OK.
Alarm Off will be displayed on the screen and the system returns to Disarmed mode.
The exit delay can also be stopped by pressing the Disarm button on the (optional) remote control.
o
If the exit delay period times out before the code can be entered, the system will be armed.
o
Extending the exit delay (remote control only)
 During the exit delay period, the delay time can be extended by pressing the Arm button on the (optional)
remote control.
 Press and hold the Arm button for 1 second and you will hear a long beep to confirm the extension of exit
time.
 Every time you press the Arm button on the remote, the delay time starts counting from the beginning.
11.3 Force arming the system
If you are entering your pin code while the system has detected an error, the control panel displays an error
message.
If you then select Away Arm and press OK, the control panel will play a warning sound indicating arming is
prohibited. The display will then alternatively display the actual errors and the message Fault Dsp.
You will need to press
If an error occurs, you can
 solve the problems and clear the error display (see section 14) and arm the system (recommended).
 ignore the errors and arm the system despite the errors, as follows:
In the Fault Dsp screen:
1. Enter your pin code and press OK. The display shows:
V. 01 – 12/06/2013
key to return back to Alarm Off Screen.
CTC1000
27 ©Velleman nv