Abus IPCA62510 Installationsanleitung Seite 23

Rubber seal for network cable:
Rubber seal for other cables (Audio input/output, Switching input/output):
Note for the installation of rubber seals:
First, run the cable through the rubber grommet. Since the cable is often kinked
during installation, it may happen that the rubber is not fully attached to the cable.
This can also occur due to too thin cable types.
Fix the cable grommet with insulating tape on the cable. This guarantees the
tightness.
The rubber seal must also be completely against the outer edge of the housing
leadthrough. If this is not the case due to cable kinks or other forces acting on the
cable, the outer edge must be sealed with silicone.
23