Applications; Setting Into Operation; Setting-Up And Connecting; Installing The Hard Disk - Monacor security NVR-104 SET Kurzanleitung

3

Applications

The NVR-104SET is designed to set up a video
surveillance system via a computer network. It con-
sists of a recorder with an integrated hard disk
(another hard disk can be built in additionally) and
two cameras of type VNC-1040. The set can be
completed to up to four cameras. For outdoor
installation the weatherproof VNC-1044 is avail-
able. The recorder and the cameras can be con-
nected via Ethernet to a local computer network or,
e. g. via a router, to larger computer networks
(Internet). The cameras can alternatively be inte-
grated into a WLAN network for wireless transmis-
sion. For correct installation, knowledge of network
technology is indispensable.
The recorder offers different facilities for control-
ling the recording (time-controlled, event-controlled,
continuously) and for evaluating events (e. g. by e-
mail message). The user interface allows easy
operation in case of live surveillance (including
communication via the audio inputs and outputs of
the cameras), recording and reproduction.
This short instruction manual offers assistance
for setting the recorder into operation in connection
with the cameras and provides basic information
for the operation. Detailed information about the
versatile configuration facilities and operating facil-
ities of the recorder are included in the detailed
English documentation (NVR Basic Series) on the
supplied CD. The cameras are provided with sepa-
rate instructions.
4

Setting into Operation

4.1 Setting-up and connecting

Set up the recorder at a place free of shock and
vibrations. The air vents on the rear side must not
be covered. For the connection and mounting of
the cameras please pay attention to the respective
camera instructions.
1) Connect the recorder to a computer network
(Ethernet) via the jack
2) If required, install a second hard disk with a max-
imum storage capacity of 1 TB into the recorder
( chapter 4.2).
3) If required, connect an external hard disk or a
flash memory to a USB port (4, 7) [additionally or
alternatively to the internal hard disk, connect it
before switching on!].
4) Connect the power supply unit provided to the
low voltage jack "DC IN 12 V/4 A" (5) and to a
socket (100 – 240 V~/ 50 – 60 Hz) via the mains
cable provided.
LAN (6).

4.2 Installing the hard disk

To install (another) hard disk:
1) Disconnect the recorder from the power supply,
if necessary, switch it off before.
2) Press the unlocking button (1) at the hard disk
support.
3) Fold out the locking lever and remove the sup-
port.
③
4) Insert the hard disk into the support and fix it with
the supplied screws.
④
5) Slide the support with the hard disk back into the
compartment and press the lever to lock it.
⑤
GB
15