Waeco MyFridge MF-40 Bedienungsanleitung Seite 20

_mf-40.book Seite 20 Montag, 3. Dezember 2007 11:08 11
Safety instructions
Never immerse the device in water.
e
Before starting the device, ensure that the power supply line
and the plug are dry.
Danger of fatal injury!
Do not touch exposed cables with your bare hands. This
especially applies when operating the device from an AC mains.
2.3 Operating the device safely at 12 V
e The cable between the battery and the cooler must be protected
by a fuse with a maximum rating of 15 A.
Only select 12 V DC operation (battery mode) if you are using a
battery monitor or if the alternator in your vehicle provides
sufficient voltage.
Only use cables with an appropriate cross section (see the table
on page 23).
2.4 Operating the appliance safely at 220 V – 240 V
e
Only use the cable supplied to connect the appliance to the AC
mains.
Never pull the plug out of the socket by the cable.
If the connection cable is damaged, you must have it replaced
by WAECO customer service to prevent possible electrical
hazards.
Before starting the device, ensure that the power supply line
and the plug are dry.
Check that the voltage specification on the type plate is the
same as that of the power supply.
20
MyFridge MF-40