Troubleshooting - Fakir Range Bedienungsanleitung

GB

Troubleshooting

Before you contact our Fakir Customer Service,
check whether you can correct the fault yourself.
WARNING!
Before you start checking the appliance,
you switch off the vacuum cleaner and
disconnect the plug from main socket.
Never use defective appliance.
Multifunction
Appliance does not
work
Appliance does not
suck up any dirt
Appliance is
making unusually
loud noises while
running
22
RANGE
Possible Cause
Plug is not plugged in or
the appliance is not
switched on.
Socket does not carry any
current.
Power cable is damaged.
Dust container is full or
blocked.
Selected brush/nozzle are
incorrect for the type of
flooring.
Filter is dirty.
Nozzle, telescopic tube or
suction hose are blocked.
Sucked-in particles are
blocking the air-way.
Solutions
Plug in the plug or switch the
appliance on
Test the cylinder vacuum
cleaner at another socket which
you are sure carries curreent
Have the cable replaced by
authorized Fakir services
Empty/clean dust container.
Adjust your brush/nozzle
selection to the type of flooring.
Clean the corresponding filter.
Make sure your Cassette filter, HEPA,
felt filter and sponge filter are clean.
Remove the blockage. If necessary,
use along wooden rod for this (e.g.a
broom handle).
Remove the particles. If
necessary, use a long wooden
rod for this (e. g. a broom
handle).