Napoleon PTSS215 Bedienungsanleitung Seite 39

ACCESSORY MOUNTING INSTRUCTIONS
Wall Mounting Instructions:
1. Using the two holes provided in the vertical tube, mount the
bracket to the wall.
2. Ensure minimum clearance to combustibles are maintained,
4" (100mm) to sides, and 6"(150mm) from the rear.
3. Do not locate the grill under unprotected combustible
construction.
4.The platform may be swivelled by removing the two #8 x 3/8"
flathead phillips screws and turning the platform to the desired
angle. Replace the two screws and tighten.
5. Once the platform is located in the desired position, the grill can be
mounted:
a. Lock the lid of the grill closed with the latch.
b. Hold the grill by the handle with one hand, place the other hand under the
grill in the centre of the front tapered surface.
c. Place the grill bottom on the platform and slide it forward to engage the tab
protruding from the bottom of the grill. Ensure that the tab is properly
engaged.
d. When the dimples on the bottom of the unit line up with the holes on the
platform, the latch is ready to be fastened.
Post Mounting Instructions:
1. Remove all the parts from the packaging.
2. Attach the post to the casting using four 1/4-20 x 1" hex head bolts. Ensure
that the holes on the back side of the post face the same direction as the groove
on the bottom back of the foot casting.
3. Place the spacers provided on the three nutserts that are closest to the front of the post.
4. Place the platform with the latch to the front onto the three spacers. Attach with the three
1/4-20 x 1 3/4" flat head bolts. Tighten firmly in place.
5. Attach the back post cover with the two #8 screws provided.
6. Once the post is completely assembled, the grill can be mounted:
a. Lock the lid of the grill closed with the latch.
b. Hold the grill by the handle with one hand, place the other hand under the grill in the centre
of the front tapered surface.
c. Place the grill bottom on the platform and slide it forward to engage the tab protruding from
the bottom of the grill. Ensure that the tab is properly engaged.
d. When the dimples on the bottom of the unit line up with the holes on the platform, the latch
is ready to be fastened.
39