Adjusting Of The Tip Cap; Adjusting The Stability And The Maneuverability - Vermeiren Eclips X4 KIDS Gebrauchsanweisung

3.12 Adjusting of the tip cap

L WARNING:
Risk of injury - Make sure that all screws are properly tightened with
the appropriate tool.
A tip cap is mounted on the lower back frame that can be adjusted in its height depending on
the seat height of the wheelchair.
The tip cap can be placed in 2 different position with a difference of 15 mm.
If an anti-tipping is installed, it replaces the addition of the tip cap and can be used
accordingly.

3.13 Adjusting the stability and the maneuverability

L WARNING:
Risk of injury - Make sure that all screws are properly tightened with
the appropriate tool.
L WARNING:
Risk of injury - Make sure that the axle adapters  of the rear
wheels on both sides are mounted in the same position.
L WARNING:
Risk of tipping over - Be aware that you change the stability of the
wheelchair.
1. Remove the screws Ⓑ.
2. Adjust the height of the tip cap to a
comfortable position.
Tip cap height
115 mm
(Standard)
130 mm
Table 3: Tip cap heights for wheelchair with
seat height of 420 mm
3. Tighten the screws properly Ⓑ.
The driving wheels are mounted in an axle adapter  at
the bottom of the back frame .
1. Loosen the fixing screws .
2. Turn the axle adapter  to the back until the axle
mounting is behind the back frame.
3. Tighten the screws properly .
4. Adjust the brakes.
Page 21
Eclips X4 kids
Tube tip cap Ⓐ Tube frame Ⓒ
Hole 1 and 3 Hole 1 and 3
Hole 1 and 3 Hole 2 and 4
(Fig C)
2016-01