Selecting Time (Tijd Progr.); Selecting Delay Start (Startuitstel); Starting The Drying Programme - AEG Electrolux LAVATHERM 88840 Benutzerinformation

70
Drying
– cycle end
– anti-crease phase and when phase starts or ends
– cycle interruption by a warning
– alarm
CHILD LOCK
The child lock can be set to prevent a programme being accidentally started or a programme
in operation being accidentally changed. The child safety device locks all buttons and the
programme knob. The child safety device can be deactivated by holding down the OPTION
(OPTIE) and OK buttons simultaneously for 5 seconds.
– Before programme is started: appliance cannot be used
– After programme is started: programme in operation cannot be changed
The child lock
child lock is not deactivated once the programme comes to an end. If you want to set a
new programme, you must first deactivate the child lock.
SPIN SPEED
If the washing in the washing machine was initially drained prior to the drying cycle, the
dryer can be set according to the spin speed of the initial drainage procedure. The higher
the spin speed was, the shorter the programme length for the drying cycle.
Activate the SPIN SPEED option and then number of times press OPTION (OPTIE) button
until the desired spin speed of the initial drainage is displayed. No value is shown if no spin
speed is selected.
In certain programmes the spin speed has no effect (time controlled cycles), its selection is
not possible and only three dashes are visualised. Available selections: from 800 to 1800
rpm's in 100 rpm's intervals.
The maximum value depends on the selected program, the minimum is always 800 rpm
For those programs where the spin speed has no effect (time controlled cycles), the selection
is not allowed and three dashes "- - -" are displayed that has the meaning of not set or
unknown.
The user interface always stores the last spin selection, and proposes it as default for all
new selected programs. If memorised spin speed is greater than maximum allowed value
it will be automatically reduced to max spin speed available for the selected program.

Selecting TIME (TIJD PROGR.)

To select the programme duration after setting the TIME (TIJD PROGR.) programme. You
can select a programme duration from 10 minutes to 3 hours in 10-minute steps.
1. Turn the programme knob to the TIMED PROGRAMME (TIJD PROGR.). The 0:10 minutes
is in the display (corresponding to the cooling phase).
2. Press the TIME (TIJD PROGR.) button repeatedly until the desired programme duration
is shown in the display, e.g. 0:20 for a programme of 20 minutes.
If the programme duration is not selected, the duration is automatically set to 10 mins.

Selecting DELAY START (STARTUITSTEL)

See chapter ProSteam system , section Selecting DELAY START (STARTUITSTEL).

Starting the drying programme

Press the START PAUSE button. The programme starts.
icon appears in the display to indicate that the child lock is activated. The