Vertical Steam Ironing; Dry Ironing - ROWENTA FerPRO-SERIES Bedienungsanleitung

FerPRO_1800113725:FerClassic_PRO_110x154mm
Do not place the iron on a metal
support. When taking a break from
ironing, always place the iron on the
iron rest plate of the unit. It is
equipped with non-slip pads and has
been designed to withstand high
temperatures.
6 • The humid steam
(depending on the model)
Set the humid steam control to suit the
user (iron held with left hand or right
hand).
Press the humid steam control 2 or 3
times - fig.9 to obtain a more powerful,
heavier burst of steam:
• for ironing thicker fabrics,
• to eliminate creases,
• for powerful vertical steam ironing.
ATTENTION: Use the humid steam
function very carefully because of the
exceptional power of steam that may
cause burns.
7 • Vertical steam ironing
Set the iron temperature control and the
steam output control dial (located on the
control panel) to the maximum position.
Hang the garment on a coat hanger and
hold the fabric slightly taut with one
hand. Press repeatedly on the steam
- fig.8 control button (beneath the iron
handle) moving the iron from top to
bottom - fig.10.
As steam is very hot: never attempt to
remove creases from a garment while
it is being worn, always hang
garments on a coat hanger. For fabrics
other than linen or cotton, hold the
iron a few centimetres from the
garment to avoid burning the fabric.
8 • Dry ironing
Do not press on the steam control
button.
28/11/08
9 • Fill the water tank again
When there is no more steam and
the"Water tank empty" light flashes
fig.11 : water tank is empty .
Remove the water tank using the handle
(on the front of the steam generator)
fig. 12 and fill it - fig. 1
the Max. level.
If this occurs, remove the excess
water.
Push the water tank into position until it
"clicks" into place. Press the Restart
button underneath the control panel.
The steam generator and the iron are
ready for use when the steam indicator
light is on and the iron indicator goes
out.
10 • Storing the steam generator
Press the illuminated on/off switch O/I
and unplug the generator. Place the iron
on the iron rest on the steam generator.
Fold the steam cord in two and place it in
its housing. Leave the steam generator
to cool for at least one hour before
putting it away if it is to be stored in a
cupboard or confined space. You can
store the steam generator in complete
safety.
5
12:39 Page 5
GB
-
-
F
do not fill above
D
NL
I
E
P
GR