Operation Telephone; Using The Telephone; Adjusting The Receiver Volume; Call Duration Display - AUDIOLINE TAB935 Bedienungsanleitung

4

Operation Telephone

4.1

Using the telephone

The telephone can be used like any conventional telephone.
1. Lift the receiver and wait until you hear a dialling tone.
2. Now dial the required telephone number.
3. To end the call, replace the receiver.
Incoming calls are accepted by lifting the receiver and are ended by replacing the
receiver.
4.2

Adjusting the receiver volume

If the receiver volume is too quiet or too loud for you, you can change this to suit
your requirements.
You can use the slide switch
volume from soft
4.3

Call Duration Display

The call duration is shown in the display in minutes and seconds during a call. The
indication starts after the number has been dialled. The call duration still remains
showing in the display for a few seconds after the call has been ended.
4.4

Redial

If a connection that you have dialled is engaged or you were unable to get
through to anybody, simply replace the receiver. The last number dialled with a
maximum of 31 digits will be saved in the telephone automatically. To use the
redial facility, proceed as follows:
Lift the receiver and press the redial button
now be dialled.
4.5

Adjustable call tone

You can use the
(high) or LO (low) to adapt the ringer volume to your requirements. Should you
not want to be disturbed, use the OFF position.
28
- Operation Telephone -
on the receiver to adjust the
to loud .
slide switch underneath the telephone to select the settings HI
. The saved redial number will