Setting The Weekly Program - Junkers EU 2 D Anleitung

EU 2 D
3.3.3 Setting/Correcting the Time
– Press and hold the
– Set the time of day with the
knob (rf).
– Release the
All weekdays and the time (in the
example: 17.28) are displayed and
the decimal point blinks (Fig. 9).
Note: The time can always be
changed independently of the other
settings (e. g., to change from sum-
mer to winter time). The switching
periods remain unchanged and do
not need to be reprogrammed.
3.3.4 Setting the Weekly
Program
The weekly program sets the same
switching periods for all days of the
week. Unused switching periods
must be deleted!
The basic program set for all days at
the factory is for heating from 06.00
to 22.00 hrs.
Changing the basic program:
– Press and hold the
the switching period that is to be
changed.
The factory setting of 06.00 is dis-
played (Fig. 10).
– Set the switching time with the
knob (rf).
– Release the
– Press and hold the
located directly below.
The factory setting of 22.00 is dis-
played (Fig. 11).
– Set the switching time with the
knob (rf).
14
button (rh).
button (rh).
button (rd) of
button (rd).
button (re)
Note: Within a heating circuit
(ch 1/ch 2), the heating periods
must not overlap.
Change or delete
switching times.
– Release the
– Change other switching periods in
the same way if desired.
Example for two switching
periods (Channel 1):
°C
6
Deleting unused switching
periods:
– Press and hold the
the switching period that is to be
deleted.
– Turn the knob (rf) to the left until
the display shows four lines
(Fig. 12).
– Release the
– Repeat the process for the
ton (re) located directly below.
Completing the setting:
– Press and hold the ∆ button (ri).
– Set the arrow with the knob (rf)
to the current day.
overlapping
button (re).
12 18 24
button (rd) of
button (rd).
but-
t