First Use - Zanussi ZFU719EW Benutzerinformation

2. To disconnect the appliance from the pow-
er disconnect the mains plug from the wall
socket.
Temperature regulation
The temperature within the appliance is control-
led by the Temperature Regulator situated on
the control panel.
To operate the appliance, proceed as follows:
• turn the Temperature Regulator toward lower
settings to obtain the minimum coldness.
• turn the Temperature Regulator toward high-
er settings to obtain the maximum coldness.
A medium setting is generally the most
suitable.
However, the exact setting should be chosen
keeping in mind that the temperature inside the
appliance depends on:
• room temperature
• how often the door is opened
• the quantity of food stored
• the location of the appliance.
Red Alarm Indicator Light
Under normal operating conditions, the internal
temperature of the freezer will ensure the long-
term conservation of the stored food.
When such temperature rises above a certain
level (-12 °C), the appliance will trigger an
acoustic and light alarm. The light alarm is a
blink red light (Red Alarm Indicator Light), while
the acoustic alarm is an intermittent sound.
You can stop the acoustic alarm by pressing
the Acoustic Signal Stop Switch once.
When switching on the freezer for the first
time, the Red Alarm Indicator Light will
blink until the internal temperature has reached

First use

Cleaning the interior
Before using the appliance for the first time,
wash the interior and all internal accessories
with lukewarm water and some neutral soap so
www.zanussi.com
a level required for the safe conservation of fro-
zen food.
Fast Freeze function
If more than 3-4 kg of food is to be frozen:
1. Press the Fast Freeze Switch for 2-3 sec-
onds to activate the fast-freeze function
6-24 hours before placing the fresh food in
the freezer, the Yellow Fast Freeze Indica-
tor Light will illuminate. The compressor will
now run continuously, to ensure that the
fresh food is frozen as quickly as possible.
2. It is possible to deactivate the function at
any time by pressing the Fast Freeze
Switch for 2-3 seconds.
3. Place the foods in the freezing compart-
ments (the first and second boxes), for
maximum freezing performance remove the
freezer tray and drawers (if the drawer is
foreseen) and then place the foods to be
frozen directly on the evaporator. In case of
freezing smaller food volumes do not need
to remove the freezer tray and drawers.
4. Once the food is completely frozen (it may
take up to 24 hours) you can manually
switch off the fast-freeze function by press-
ing the Fast Freeze Switch for 2- 3 sec-
onds and the Yellow Fast Freeze Indicator
light will also go out.
5. Move frozen food from the freezing com-
partments into the other three compart-
ments (storing compartments) to make
room for another freezing.
If the Fast Freeze Switch is accidentally
left on, the fast-freeze function will be au-
tomatically switched off 48 hours later. The Yel-
low Fast Freeze Indicator light will also go out.
as to remove the typical smell of a brand-new
product, then dry thoroughly.
Important! Do not use detergents or abrasive
powders, as these will damage the finish.
29