Removing / Inserting The Battery; Recharging The Battery; Used Batteries; Assembling Instructions - Grizzly CT 1800 Li Originalbetriebsanleitung

GB
OEM spare battery available from
our Customer Service.
• Always take heed of the applicable
safety instructions as well as the
environmental protection regulati-
ons and information.
• The warranty excludes all defects
caused by improper handling.

Removing / inserting the battery

1. To remove the battery (16) from
the appliance, press the release
button (17) on the battery and
pull out the battery.
2. To insert the battery (16), place
it on the guide track (20) and
push it back into the appliance.
It will audibly snap in.
Do not insert the battery until
the appliance is fully assembled.
Risk of injury!

Recharging the battery

Recharge the battery when the last
charge state indicator LED (
changes from green to orange/red.
When starting to charge and while
charging, the battery charge indica-
tor ( 19) lights up red.
When charging is over, the light
changes to green.
1. Remove the battery (16) from
the appliance, as necessary.
2. Inser the battery (16) in the
charging compartment of the
battery charger (19). It will audi-
bly snap in.
3. Plug the battery charger (19) into
a mains outlet. The charging in-
dicator (19a) lights up:
30
Red: Equipment charging.
Green: Charging finished.
The recommended charging
time is approx. 3-5 hours.
4. When the battery is fully re-
charged unplug the battery
charger (19) from the mains.
5. Press the release button (
on the battery (16) and pull the
battery out of the battery charger
(19).

Used batteries

• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to
be replaced. Only use an OEM battery
pack replacement available from our
Customer Service.
• Always take heed of the applicable
safety instructions as well as the envi-
ronmental protection regulations and
information (see "Cleaning and Main-
tenance").

Assembling instructions

18)
Do not insert the battery until
the appliance is fully assembled.
Risk of injury!
To put together the equipment:
1. Turn the black twist lock (24)
on the motor head (10) until the
notches match up to those in the
green casing. Lock open symbol
2. When plugging in the telescopic
tube (9) be aware of the different
plastic pin thicknesses on the
tube. Only one position is possi-
ble.
.
17)