Marmitek BOMBOOM 50 Gebrauchsanleitung Seite 11

I am unable to automatically connect to my headphones.
If you do not automatically get a connection to your headset, press
the button for 0.5 seconds (the BoomBoom 50 then goes into
pairing mode) and put the headset in pairing mode.
Can I only use the BoomBoom 50 with headphones?
No, you can use the BoomBoom 50 with any Bluetooth device
with audio playback capability. Including, for example, a Bluetooth
speaker or a Marmitek BoomBoom 90 Bluetooth music receiver. If
attached to your audio system, you can choose whether you want
to hear the sound using the audio system and/or your
headphones, or through the TV's speakers.
Whenever I watch TV, audio is out of sync with video.
The wireless transmission of audio over Bluetooth may indeed
result in some delay (latency).
In most cases, this latency is not disturbing, only some of the
users may experience this as a nuisance.
If you use a media box to watch TV, connect the BoomBoom 50 to
the audio output of your media box. This results in reduced
latency.
The sound is distorted by a hum or interference
If you do not use an adapter to power the BoomBoom 50, but, for
example, connect it to your audio system's USB connector, the
resulting ground loop may sometimes cause a hum. In this case,
use a USB power adapter (such as the Marmitek USB power
adapter). Using a USB port on, for example, a PC may also cause
interference.
Do you have any other questions that have not been resolved by
the above information? Please go to www.marmitek.com
BoomBoom 50 11