eta ANDARE ANIMAL Bedienungsanleitung Seite 25

If the protection micro filter is very dirty, you can also rinse the pleated side
of the HEPA filter under lukewarm slow-running tap. Hold the filter in such
a way that the pleated side points upwards and the water flows parallel to
the pleats. Hold the filter at an angle so that the water washes away the dirt
inside the pleats. Turn the filter 180° and let the water flow along the pleats
in the opposite direction. Continue this process until the filter is clean. After
drying, insert the cartridge back to the vacuum cleaner in the opposite way.
Clean all other parts (i.e. container, separator, foam micro-filter) in running lukewarm
water, e.g. using a cloth or a soft brush and let it dry completely. Re-assemble individual
parts in the opposite direction.
Exhaust micro-filter
Push the lock in the lower part of exhaust cover A10, then lift off the cover and remove
it from the vacuum cleaner (Fig. 17). Pull out micro-filter A9. Put the new micro-filter back
to the vacuum cleaner in the opposite direction. Insert the lugs on the back cover into two
holes in the vacuum cleaner cover and snap the cover.
CAUTION
– Do not use any aggressive washing or cleaning agents or hot water to clean the HEPA
filter and the micro–filter.
– Cleaning the filter will not restore its original colour, but it will restore its filtration properties.
– The dust container is not resistant to cleaning in a dishwasher.
– The HEPA filter and the micro–filters are not intended for cleaning in a dishwasher.
– Proper insertion of micro–filters into the container will enable securing the mechanical
safety lock. Now you can put the container into the vacuum cleaner.
– The safety lock will not make it possible to put the container into the vacuum cleaner
if you forget to insert the micro–filters.
– Neglecting regular replacement of micro–filters can result in the vacuum cleaner defect!
– Make sure that the binding surfaces and sealing elements are functional.
– We recommend replacing the HEPA filter 2x a year. Replace the other filters if they
cannot be cleaned properly or if they are damaged. You can buy a spare HEPA filter
and micro-filters in the network of elektro shops.
DermoPet ADAPTER
Mounting and removing of accessories
– slide accessory (D2/D3/A4) into the nozzle D untill it clicks into the place.
Pull on the accessory to remove it from the nozzle D.
– Assemble the D1 accessory on the front part of the nozzle and slide it on with a slight
pressure. The accessory is assembled correctly if it moves freely. Pull on the accessory
to remove it from the nozzle.
– Use the accessory D5 in case if the vacuum cleaner has trunk hose with a diametr 32 mm.
Before the first use of we recommend to use the nozzle with switched off vacuum cleaner.
It will help the animal to get accustomed to the way of cleaning. Subsequently leave
sufficient time for an animal to be accustomed to the sound of the vacuum cleaner (better
with the presence of the owner). It will help to avoid the animal being stressed, nervous,
irritated, etc.
25 / 53
GB