oneConcept Bergen Bedienungsanleitung Seite 19

77.5 kHz, reception area is a radius of 2000km around Mainflingen near Frankfurt am Main,
Germany) begins 3 minutes after the established connection of indoor unit and outdoor
unit. A corresponding "radio"-icon will be displayed (flashes during connection attempt).
Manual setup (when the radio clock signal can not be found):
• Press and hold + and - for 3 seconds to interrupt the automatic radio clock signal scan.
• Press and hold MODE for 3 seconds to switch to setup mode. The year display starts to
flash. Adjust with the buttons +/-. Press MODE to confirm.
• Repeat this procedure for adjusting the
• month
• date
• time zone (in relativity to CET. For London enter "+1", for Moskow enter "-3" etc.)
• display language
• 12h / 24h display
• hour
• minutes
Please note: The clock automatically changes from set-up mode to time display mode if
no keys are pressed for 20 seconds.
Set alarms
• Press MODE to switch from time display to A1 (Alarm 1) display.
• Press and hold MODE for 3 seconds. The alarm time is shown with the hour flashing. Adjust
the alarm hour with +/- and press MODE to confirm. Repeat the procedure for setting the
minutes and press MODE again.
• Now the A2 (Alarm 2) display is shown. Repeat the procedure for setting alarm 2.
Please note: The clock automatically changes from set-up mode to time display mode if
no keys are pressed for 20 seconds.
Activate/deactivate alarms
• Press MODE to switch to the A1 or A2 display and press "-" , to activate or deactivate the
respective alarm. An alarm clock symbol on the display indicates active alarms.
Please note: Alarm1 is active on weekdays only; alarm2 is active on weekends only.
Please note: The clock automatically changes from set-up mode to time display mode if
no keys are pressed for 20 seconds.
Snooze
Alarms
19