Setting Into Operation; Power Supply - Monacor TXA-602/SW Bedienungsanleitung

4 Setting into Operation

4.1 Setting up the active speaker
system
Place the active speaker system as desired or
mount it onto a PA speaker stand (e . g . PAST
series from MONACOR) via the stand sleeve on
its lower side .
The unit can be operated inside its transport
bag: Unzip the zip fasteners of the flaps covering
the speakers, the connections and the operating
elements . Fold up the flaps and secure them
with hook-and-loop fasteners .

4.2 Power supply

The speaker system is supplied with power via
the integrated battery which is charged via the
internal charger .
1) For charging the battery, connect the mains
cable provided to the mains jack (17) and con-
nect the mains plug to a socket (230 V/ 50 Hz) .
2) The LED CHARGE (5) lights up:
red = the battery is being charged
green = the charging process has been com-
pleted
The unit may be operated while its battery
is charged; however, as long as the red LED
LOW lights up, the full power is not available .
To reduce the charging time, switch off the
unit with the POWER switch (13) .
3) When the battery has been fully charged, the
LED CHARGE lights up in green . At maximum
volume, a mains-independent operating time
of up to 10 hours will be possible . A lower
volume will extend the operating time .
4) Recharge the battery when the red LED LOW
lights up .
Important!
Always disconnect the mains plug from the
socket when the battery has been fully charged
(LED CHARGE lights up in green) and the unit
is not operated; otherwise, the battery may
be damaged .
10
4.3 Connecting the active speaker system
Unit
Microphone with XLR plug MIC / LINE (1)
Audio units with line
output, e. g.: mixer,
MP3 / CD player, radio,
microphone preamplifier
Active speaker system
Passive speaker system
5 Operation
Function
1. Switching the unit on / off switch POWER (13)
2. Switching the internal
speakers on / off
3. Volume for a microphone
or audio unit connected
to the jack MIC / LINE (1)
4. Volume for one or two
wireless microphones
5. Sound for all microphones
and an audio unit
connected to the jack
MIC / LINE (1)
6. Volume for an audio unit
connected to the jack
LINE IN (6)
7. Sound for an audio unit
connected to the jack
LINE IN (6)
Hint: To save battery power, always remember to
switch off the wireless microphones after operation .
5.1 Limiter
The red LED LIMITER (14) lights up when the
limiter limits the volume at the maximum undis-
torted level . If the LED lights permanently, use
the control LEVEL (2 or 8) to reduce the volume .
Connection to jack
LINE IN (6) and
with 6.3 mm plug to
MIC / LINE (1) if no
microphone is connected
LINE LINK (7)
If a second speaker system
TXA-602 / SW is used,
connect its input LINE IN
to the output LINE LINK of
the first speaker system.
EXTERNAL SPEAKER (15)
Operating element
switch INTERNAL
SPEAKER (16)
control LEVEL (2)
control
WIRELESS MIC (3)
controls BASS,
MIDDLE and
TREBLE (4)
control LEVEL (8)
controls BASS and
TREBLE (9)