Water Tank & Drain Hose - INVENTOR Avra Bedienungsanleitung

INDICATIONS
WATER TANK FULL
Indicator turns red when tank is full, removed, or misplaced.
• The water level control switch shuts off the dehumidifier when the water
tank is full, removed or misplaced.
AUTO DEFROST
When frost builds up on the evaporator coils, the compressor will cycle off and the fan
will continue to run until the frost disappears. The "Defrost" indicator will then turn on.
• This function not only ensures the safe and appropriate operation of the
dehumidifier but is also more efficient and economical in its performance.
7. WATER TANK & DRAIN HOSE
There are two ways to remove collected water. Before proceeding ensure that you have
switched off and unplugged the unit.
1. Usage of the water tank
When unit is OFF and the tank of the dehumidifier is full, the full indicator will be lit
and the display will read P2. Additionally, when the unit is on and the tank is full, the
compressor stops operation followed by the fan a few minutes later. The full indicator
will flash and the display will show P2.
• Slowly remove the bucket. Grip the handle with caution and carefully pull outwards so
the water does not overflow. Do not place the tank on the floor because the bottom of
the tank is uneven. Doing so the tank will fall and the water will be spilled on the floor.
• Empty the water from the tank and place it again in to the device. The water tank,
must be securely and properly placed, for the dehumidifier to operate.
• When the water tank is re-installed the unit will automatically restart.
EN
Note: When Auto Defrost is operating, the unit may cause
some noise of the refrigerant fluids flowing, this is normal.
• When you remove the tank, do not touch any parts
inside the unit, as you may damage the device.
• Be sure to gently place the tank into the dehumidifier.
• Do not drink or use the collected water from the
device.
• Wipe any excess water on or in the unit when
removing the tank.
11