All operating elements and connections de -
scribed can be found on page 2.
1 Applications
This spotlight is suitable for effect illumination, e. g.
on stage or in festival rooms. It creates coloured
light via super bright 10 mm LEDs and can be oper-
ated in different modes (e. g. constant light or stro-
boscope light, automatic change of colours). The
spotlight is designed for operation via a light con-
troller with DMX512 protocol (4 or 8 DMX channels),
but it can also be operated without controller, either
as an individual unit or interconnected with several
LITEBOX-10 units in the master/slave mode.
The power can be supplied via the 230 V mains
or via the integrated lithium ion rechargeable battery
which can be recharged when connecting the unit to
the mains. Thus, the spotlight is ideally suited for
mobile applications. Via two brackets it can be set up
quickly and easily at different places of application.
2 Safety Notes
The unit corresponds to all relevant directives of
the EU and is therefore marked with
WARNING The unit is supplied with hazardous
mains voltage. Leave servicing to
skilled personnel only and do not
insert anything through the air vents.
Inexpert handling or modification of
the unit may cause an electric shock
hazard.
It is essential to observe the following items:
WARNING Do not look directly into the light
source for a longer time, this may
lead to eye damage.
Please note that stroboscope effects
and fast changes in colour may
trigger epileptic seizures with photo-
sensitive persons or persons with
epilepsy!
G
The unit is suitable for indoor use only. Protect it
against dripping water and splash water, high air
humidity and heat (admissible ambient tempera-
ture range 0 – 40 °C).
G
Do not place any vessels filled with liquid, e. g.
drinking glasses, on the unit.
G
Do not set the unit into operation and immediately
disconnect the mains plug from the mains socket
1. if there is visible damage to the unit or to the
mains cable,
2. if a defect might have occurred after a drop or
similar accident,
3. if malfunctions occur.
The unit must in any case be repaired by skilled
personnel.
G
Never pull the mains cable to disconnect the
mains plug from the mains socket, always seize
the plug.
G
Only replace a blown fuse by one of the same
type.
G
No guarantee claims for the unit and no liability
for any resulting personal damage or material
damage will be accepted if the unit is used for
other purposes than originally intended, if it is not
safely mounted, not correctly operated, or not
repaired in an expert way.
G
Important for U. K. Customers!
The wires in this mains lead are coloured in ac -
cord ance with the following code:
green/yellow = earth, blue = neutral, brown = live
As the colours of the wires in the mains lead of
this appliance may not correspond with the
coloured markings identifying the terminals in
your plug, proceed as follows:
1. The wire which is coloured green and yellow
.
must be connected to the terminal in the plug
which is marked with the letter E or by the earth
symbol , or coloured green or green and yel-
low.
2. The wire which is coloured blue must be con-
nected to the terminal which is marked with the
letter N or coloured black.
3. The wire which is coloured brown must be con-
nected to the terminal which is marked with the
letter L or coloured red.
Warning – This appliance must be earthed.
3 Setting-up / Mounting
To prevent heat accumulation inside the unit,
always place it so that a sufficient air circulation is
ensured during operation (minimum distance to
adjoining walls 15 cm). Never cover the air vents
at the housing.
Tightly screw the brackets (A) with the supplied
screws (B) at the unit
The unit may
– be placed on the floor by unfolding the brackets or
– be mounted via the two brackets or the greater
one, e. g. with a stable mounting screw to a cross
bar.
If the unit is to be put out of operation
definitively, take it to a local recycling plant
for a disposal which is not harmful to the
environment.
fig. on page 2.
GB
9