Technical Information - Philips GC4549 Benutzerhandbuch

Problem
The ironing board
cover becomes
wet or there are
water droplets on
the garment during
ironing.
The iron does not
produce a steam
boost.
Dirty water and
impurities come
out of the soleplate
during ironing.
Possible cause
Steam has condensed
on the ironing board
cover after a long ironing
session.
You have an ironing
board cover that is not
designed to cope with
the high steam rate of the
appliance.
You have used the steam
boost function too often
within a short period.
Hard water with impurities
or chemicals has formed
flakes inside the soleplate.

Technical information

- Rated power: 2200-2600 W
- Rated voltage: 220-240 V
- Rated frequency: 50-60 Hz
Solution
Replace the ironing board cover
if the foam material has worn out.
You can also add an extra layer of
felt material under the ironing board
cover to prevent condensation on
the ironing board. You can buy felt
in a fabric shop.
Put an extra layer of felt material
under the ironing board cover to
prevent condensation on the ironing
board. You can buy felt in a fabric
shop.
Continue ironing in horizontal
position and wait a while before you
use the steam boost function again.
Perform Quick Calc Release.
See chapter "Cleaning and
maintenance".
ENGLISH
19