Cleaning And Storing The Device And Cuff; Rectifying Faults; Specifications - Beurer BM 45 Gebrauchsanweisung

• When the relevant memory button (M1 or
M2) is pressed again, the last individual
measurement is displayed (in this example,
measurement 03).
• When the relevant memory button (M1 or M2) is
pressed again, you can view your individual measure-
ments.
• To switch the device off again, press the Start/stop
button or wait 30 sec.
You can exit the menu at any time by pressing the
Start/stop button .
• To clear the memory of the relevant user memory, you
must first select a user memory.
• Start individual measurement access.
• Press and hold the M1 & M2 memory buttons for 5
seconds.
All the values in the current user memory are
deleted.

8. Cleaning and storing the device and cuff

• Clean the device and cuff carefully using a slightly damp
cloth only.
• Do not use any cleaning agents or solvents.
• Under no circumstances hold the device and cuff under wa-
ter, as this can cause liquid to enter and damage the device
and cuff.
• If you store the device and cuff, do not place heavy objects
on the device and cuff. Remove the batteries. The cuff line
should not be bent sharply.

9. Rectifying faults

In the event of errors, the
display. Error messages may appear if:
• it was not possible to record the pulse: E1;
• you move or speak during the measurement: E2;
• the cuff is fastened too tightly or loosely: E3;
• errors occur during the measurement: E4;
• the pump pressure is higher than 300 mmHg: E5;
are almost empty: E6.
• the batteries
In such cases, repeat the measurement. Ensure that the cuff
line is correctly attached and that you do not move or speak. If
necessary, reinsert or replace the batteries.

10. Specifications

Model no.
Type
Measurement
method
26
error message appears on the
BM 45
M1501
Oscillometric, non-invasive blood pres-
sure measurement on the upper arm