Rane HA6S Benutzerhandbuch Seite 4

Setup
1. Switch everything on in the following order:
• audio input sources (i.e. instruments, CD/MP3 players)
• HA6S
• speakers/amps
2. When turning off, always reverse this operation:
• speakers/amps
• HA6S
• last, any input sources
Using the Main Input Connectors
1. Connect your source to the rear panel main input connectors on HA6S.
2. Set the input gain (Main section) and the balance control (Channel section) on center position. Set the
output gain of each channel all the way down.
3. Check the input level meter for optimal signal.
4. Connect headphones to HA6S and start to raise the output gain of each channel to the desired listening
volume.
Main
Outputs
Using the Aux Inputs
You can also play back a signal to feed in a vocal microphone and then connect a mixer's Aux send to
HA6S's Aux input. Use the balance control to give the vocalist the desired mix between the voice and the
playback signal. Then, adjust the output gain control to regulate the overall desired volume.
Main
Outputs
4
Aux Send