Installing; Specifications - Quadral AURUM A10S Bedienungsanleitung

1. Select the correct voltage required on the back of the unit amplifier that matches the voltage coming
from the mains supply. Use the power cable supplied in the package to connect the equipment up to the
mains supply.
2. Check that the unit is switched off.
3. Connect up the auxiliary units that you want to use to the equipment's inputs. (RCA 1-3, TosLink, SPDIF,
USB) right channel = red / left channel = white or the symmetric analog XLR inputs can be used with
any compatible signal source.
(XLR pin assignments: Pin 1= ground; Pin 2 = plus / signal; Pin 3 = minus)
4. The screw terminals at the back are used for the speaker connections.
5. (See back of the equipment: right channel = 1 / left channel = 7). You must also ensure that the plus
and minus connections on the amplifier concur with the plus and minus connections on the speakers in
order to prevent polarity reversal.
6. Now switch your amplifier on.
Switch the mains switch (12) into the ON position on the back. The standby LED on the front will come
on.
7. Now press the multifunction knob (2) on the front or the button (2) on the remote control to start your
equipment.
Note:
As your A10S uses a special power-saving standby circuit, you can always switch on / off during normal
operation using the multifunction knob on the unit or the RC-3 remote control.
The RC-3 remote control makes it easier for you to change your settings.
Mute (button 2)
Balance setting (buttons 14 + 15)
Input settings for all jacks (button 3 + 4)
Example: Input settings
Select the signal source using buttons 11 (-) or 12 (+), then press button 22 (Prog.) and use the volume but-
tons (3 + 4) to set the desired input volume. To save, press button 22 (Prog.) again.
12

INSTALLING

SPECIFICATIONS

A10S
Input sensitivity for 1W @8ohms -16,3 dBV
Input impedance 47kOhm
Voltage gain 38dB
Maximum input voltage 6V
Volume adjustment range 100dB
Balance adjustment range +/-6dB
Adjustment accuracy 0.1dB
Channel balance <0,05dB
Maximum voltage at speaker output 48V
Minimum speaker impedance 2.5 Ohm
Output power at 8 ohms 100W
Output power at 4 ohms 180W
Frequency response 1Hz-110kHz(-3dB)
Harmonic distortion <0.03%
Signal-to-noise ratio 75dB unweighted
Mains power connection 115V/230V switch
Power consumption in normal mode 15W
Power consumption at max volume 600W
Power consumption in standby mode <0,5W
Inputs 3 RCA
1 Line XLR
2 TosLink
1 SPDIF
1 USB
Speaker outputs 1 pair
Dimensions
Width including wooden sides 453 mm
Height including feet 130 mm
Depth with speaker terminals 345 mm
Weight 13.86Kg
EN
13