Cleaning Of The Water Inlet Valve; Frozen" Appliance - Pkm WA6-1008E Bedienungsanleitung

5.4 Cleaning of the water inlet valve

 The water inlet valve has to be cleaned, when it is not or improperly supplied
with water with the tap opened.
1. Close the water tap.
2. Disconnect the appliance from the mains (unplug).
3. Remove the water inlet hose from the washing machine.
4. Remove the filter net from the water valve.
5. Clean the filter net using some water and a toothbrush.
6. Reinstall the filter net properly.
7. Reconnect the water inlet hose to the appliance again.
A

5.5 "Frozen" appliance

If the ambient temperature is lower than 0
proceed as described below:
1. Disconnect the appliance from the mains.
2. Close the water tap.
3. Wash the tap with warm water (approx. 50
hose off.
4. Take off the hose and immerse it in warm water (approx. 50
5. Pour warm water (2 - 3 litres / approx. 50
10 minutes.
6. Reconnect the water inlet hose to the tap and check, that the water inlet and the
water drain works properly.
7. When you operate the appliance again, the ambient temperature must be higher
0
than 0 C.
V
ALVE OF THE WATER INLET
0
C and the appliance has been frozen,
0
C) so you can take the water inlet
0
C) into the drum and wait approx.
70
0
C).