Starting Operation - Bosch AXT 22 D Originalbetriebsanleitung

The circuit must at least be protected as fol-
lows:
AXT 22 D/25 D/23 TC/25 TC = 16 A
An extension cable with a cross section that is
too small causes a distinct reduction in the per-
formance capabilities of the machine. For ca-
bles to 25 m in length, a cross section of at least
2
3 x 1.5 mm is required, for cables more than
25 m in length, the cross section must be at
2
least 2.5 mm .
WARNING! Inadequate extension cables can
be dangerous. Extension cable, plug and sock-
et must be of watertight construction and in-
tended for outdoor use.
Cable connections should be kept dry and off
ground.
It is recommended for increased electrical safe-
ty to use a Residual Current Device (RCD) with
a tripping current of not more than 30 mA. Al-
ways check your RCD every time you use it.
If the supply cord is damaged, it must be re-
placed by a Bosch Service Centre.
When using cable drums, these must be com-
pletely unreeled.
Products sold in GB only: Your product is fitted
with an BS 1363/A approved electric plug with
internal fuse (ASTA approved to BS 1362).
If the plug is not suitable for your socket outlets,
it should be cut off and an appropriate plug fit-
ted in its place by an authorised customer serv-
ice agent. The replacement plug should have the
same fuse rating as the original plug.
The severed plug must be disposed of to avoid a
possible shock hazard and should never be in-
serted into a mains socket elsewhere.
Assembly
Remove the machine from the package.
(see figures A–D)
Assemble the chute
Lift back blade cover plate 13.
Hook in chute assembly 8 to the machine.
Turn red clamping knob 9 fully clockwise to
lock the chute 8 in place.
Bosch Power Tools
E F
Operation

Starting Operation

Always place the machine on firm level
ground. During operation, do not tilt or
move.
The motor will coast after switching off!
Remove earth from roots. Foreign material such
as stones, glass, metals, fabrics or plastics must
not enter the chute assembly 8. Otherwise this
could damage the cutting roller 16.
The chute assembly 8 must be empty.
Starting
Press green button 4.
Stopping
Press red "stop" button 5.
Restarting Protection
A mains failure causes machine to switch off.
The machine cannot restart on its own when the
power returns.
Return Motion
Press and hold the yellow button 6 to reverse
the feed.
The cutting roller 16 runs backward and frees
jammed material.
Overload Protection
Overloading (e. g. blocking of the cutting roller
16) causes the machine to stop after a few sec-
onds. Press and hold the yellow button 6 to re-
verse the cutter to unblock. If the blockage can-
not be cleared the pressure plate 15 will need to
moved away from the cutter.
The adjustment knob 10 will need to be turned
a anti clock wise direction a small amount until
the "jammed" material is clear. The pressure
plate 15 will need adjustment (see "Pressure
Plate Adjustment").
English | 19
G
F 016 L70 603 | (30.4.09)