bp Hi-Vis Protect Bedienungsanleitung Seite 11

• Do not use any highly alkaline detergents.
• Do not use fabric softener.
• Do not use detergents containing whitening agents.
• Do not use detergents containing sodium hydroxide, potassium hydroxide or caustic
alkali.
• The detergent dosage must be such that the alkali concentration
does not exceed the following values:
Parameter Guide value
pH value 10.0 to 11.0
_ < 600 mg/l
Active alkalinity
sodium oxide
• Drying recommendations for drum dryers:
• Filling ratio 1:25
• Inlet temperature not higher than 120°C.
• The exhaust air temperature must not exceed 90°C.
• The residual moisture in the clothing items must not fall below 3%.
• Drying recommendations for tunnel finishers:
• The inlet temperature must not exceed 160°C.
• The spray steam pressure must not exceed 4 bar.
• Do not overdry. The items of clothing must not be subjected to a temperature
higher than 135° C.
The residual moisture in the items of clothing must not fall below 3% at any time.
Aftercare/checking:
• The protective clothing must be proofed after each care cycle so that the protective
action against chemicals is maintained.
• Post-treatment must be carried out in accordance with the recommendations of the
proofi ng agent manufacturer. It must not reduce the fl ame resistance characteristics of
the fabric. The latter must be checked and validated. In doing so, the care recommenda-
tions for this protective clothing must be taken into account and must not be restricted.
• In particular, the resistance to chemicals must be checked after each care cycle in
accordance with the requirements of EN 13034 type 6.
• After each care cycle, the standardized function of the protective clothing must be
checked as per EN ISO 20471.
Maximum
_ < 11.0
_ < 900 mg/l
Expiry date/expiry time:
Maximum 5 years.
Disposal:
When disposing of the protective clothing, the relevant statutory requirements
are to be observed. In particular, the substances with which the protective
clothing was contami n ated during use must be taken into account in the disposal
process.
Manufacturer:
Bierbaum–Proenen GmbH & Co. KG, Domstr. 55–73, 50668 Köln, Germany,
tel. +49 221 16 56 0, fax +49 221 16 56 170, www.bp-online.com