Assembly Instruction - SPORTSTECH SX100 Benutzerhandbuch

4) ASSEMBLY INSTRUCTION

Preparation
A. Before assembling make sure that you will have enough space around the item.
B. Use the present tooling for assembling.
C. Before assembling please check whether all needed parts are available (at the above of this
instruction sheet
you will find an explosion drawing with all single parts (marked with numbers) which this
item consists of.
Assembly Instruction:
1.2
2
1) Connect the front tube with the frame, and install
the plain washer
on the cover-shaped screws. And use open spanner
to fasten them. Installation of back tube is the same.
Note: Please
to make it balance if it is not stable.
1
2) The feet straps are marked with L and R. Plea-
se drop 2 red screw locking liquid in R strap and
fasten it with right threaded hole by using our
spanner. And drop 2 red screw locking liquid
in L strap and fasten it with left threaded hole.
(Note: L and R are marked in crank as well. Plea-
se install them accordingly otherwise it will da-
mage the products. And please fasten the feet
2.2
strap, or it will fall down after long usage.)
27
Ø
10, washer 10 to the bolts and put
adjust the black feet strap